Open furnace cabinet with the blower and cabinet floor covered in dust

HVAC System Cleaning in Sonoma County

A clean fan, a clean coil and a clean furnace cabinet, so the whole system works less.

Call (707) 232-8733

Free estimate, no obligation. Get a Free Estimate

Get a Free Estimate

Rather talk? Call (707) 232-8733

Optional

Your ducts are the roads. The furnace or air handler is the engine, and it gets dirty in ways the roads don't. A filter sits in front of it, but no filter seals perfectly, and years of fine dust end up coating the parts that do the real work. The fan that moves the air picks up a crust on its blades. The coil that cools the air in summer clogs between its thin metal fins. In Cloverdale, where summer afternoons are often in the 90s, a clogged coil means an AC that runs all day and still can't keep up. In Sebastopol the trouble is more often dampness, with a furnace in a cool crawl space that smells musty every fall.

Read on for the symptoms, a plain description of each part, what our cleaning includes and what you can do yourself. This service pairs with our air duct cleaning, and most people book the two together.

How a Dirty System Acts

It runs longer. That's the main one. The thermostat is set where it always was, but the cycles stretch out and the gas or electric bill creeps up. Air at the vents feels weaker than it used to. In cooling season you might find ice on the copper lines near the furnace, or water in the pan under it. In heating season there's a burnt-dust smell that lasts well past the first cold night. Some systems start short cycling, shutting off on a safety limit because the heat can't get out of the cabinet fast enough. Any one of these is worth a look inside.

Blower, Coil and Drain Pan

Three parts collect most of the dirt. The blower is a drum-shaped fan with dozens of small curved blades. Each blade is cupped to scoop air, and when dust fills the cup, the fan spins just as fast but moves far less. The evaporator coil is the cold part of the air conditioner. It looks like a car radiator folded into an A shape, and air has to squeeze between its fins. Since it's wet whenever the AC runs, dust sticks to it and turns to paste. Under the coil sits the drain pan, which catches the water that drips off and sends it outside through a small pipe. Slime can plug that pipe, and then the pan overflows.

What Our Cleaning Includes

We cut the power, take the cabinet door off and slide the blower assembly out and clean the wheel blade by blade, along with its housing and motor. The coil is brushed and vacuumed on the dirty side, then washed with a foaming coil cleaner and rinsed so the fins are open again. We flush the drain pan and the drain line and make sure water runs freely. The cabinet walls and the filter slot are vacuumed and wiped down. Everything goes back together, the power comes on and we run the system to check airflow and listen for anything that sounds wrong. Allow one to two hours on top of a duct cleaning.

What You Can Do Yourself

The filter is your job, and it matters more than anything we do. Buy the right size, so there are no gaps around the edge, and change it every one to three months. Write the date on the frame. Keep the area around the furnace clear, particularly in a garage where sawdust, pet hair and dryer lint float around. Outside, hose off the AC condenser each spring and trim plants back two feet from it. Once a year, pour a cup of white vinegar down the drain line's cleanout if your system has one. Do those few things and a professional cleaning will hold for years.

If the laundry sits near your furnace, lint is likely part of what we'll find in there, so ask about dryer vent cleaning while we're on site.

Frequently Asked Questions

Yes. It happens a lot. An air conditioner needs a steady stream of warm house air crossing the coil. When dust chokes off that stream, the coil gets too cold and the moisture on it turns to ice. The ice blocks even more air, and soon nothing comes out of the vents. Turn the system off, let it thaw and have the coil and blower checked.

Have the ducts cleaned before, or on the same day. New equipment arrives clean, and connecting it to dusty ductwork means the first thing it does is pull that dust through a brand-new blower and coil. If the furnace is already in, a duct cleaning soon after still protects it. A new unit shouldn't need its own cleaning for several years if the filter is changed on time.

The power to the furnace or air handler is switched off while the cabinet is open, which is basic safety around a blower motor. The gas valve at the unit is closed if we need to move anything near the burners. Both go back on before we leave, and we run a full heating or cooling cycle to confirm the system starts and runs the way it should.

Request a Free Estimate

Rather talk? Call (707) 232-8733

Optional

Our Sonoma County Service Areas

MENDOCINO LAKE NAPA MARIN PACIFIC OCEAN Santa Rosa Petaluma Rohnert Park Cotati Windsor Healdsburg Sebastopol Sonoma Cloverdale

Curious what's inside your ducts? Call (707) 232-8733. The estimate costs nothing.

Call Now
Call (707) 232-8733