Walk into most houses with a flashlight, lift a floor vent and look down. You'll see a gray fuzz on the metal, a few pet toys, maybe a handful of drywall screws from a remodel twenty years ago. None of it is unusual. A duct system is a set of metal and plastic tunnels that carries every bit of heated and cooled air in the house, and no one ever sees inside it. In Santa Rosa, plenty of those tunnels also hold fine ash from the 2017 fires. In the Sonoma Valley, the Nuns Fire left the same thing behind. The system keeps moving air across all of it, every day.
On this page: the signs worth paying attention to, the two types of ductwork in local homes, how our visit runs and how to stretch the time between cleanings. Slow laundry is a separate issue with a separate pipe, and you'll find that under dryer vent cleaning.
When Ducts Need Attention
Dust is the obvious one. If shelves near a vent need wiping every few days, or you see puffs come out when the fan starts, the ducts are feeding it. Smell is the second. A stale or smoky odor in the first minute of a cycle points to buildup on the return side. Uneven rooms are the third: when one room runs five degrees off from the rest, a blocked or disconnected run is often why. Then there are events. A kitchen or bath remodel, new hardwood, mice under the house or a smoke season with the windows shut all load the system faster than years of normal living.
Sheet Metal vs. Flex Duct
Local homes have two main kinds of ductwork, and they can't be cleaned the same way. Houses built before the 1980s mostly have rigid sheet metal, round or rectangular, often running through the crawl space. Metal is tough. It takes a spinning brush well and comes back nearly bare. Newer homes and most remodels use flex duct, a plastic liner wrapped around a wire coil with insulation over it. Flex tears and crushes easily, so it gets compressed-air tools that knock dust loose without scraping the liner. The cleaning standard published by NADCA, the industry's trade association, requires matching the method to the material. Ask any company which tools they use on flex. A good one will have a quick answer.
What Happens During Our Visit
First we count vents and locate the furnace, the returns and the way into the attic or crawl space. Drop cloths go down. A large hose joins the vacuum to the trunk duct beside the furnace, and once it's on, the whole system is under suction. We close off the vents so the pull stays strong, then open them one at a time and send a brush or air tool down each run toward the vacuum. Returns come next, since they're usually the dirtiest. Vent covers get washed. The access hole in the trunk is sealed with a metal plate. A typical house keeps us busy for two to four hours. You get before and after photos of the inside.
Making a Cleaning Last
A cleaning lasts as long as the filter lets it. NADCA puts most homes on a three-to-five-year cycle, and good habits can push you to the long end of that. Look at the filter once a month and swap it as soon as it turns gray. During smoke season, the EPA recommends a filter rated MERV 13 if your system can handle it, and running the fan with the windows closed. Keep floor vents clear of rugs and furniture so dust isn't pulled in around them. Vacuum the return grille when you vacuum the room. And after any remodel, have the ducts checked before the dust has a year to spread.
Clean ducts attached to a dirty furnace won't stay clean for long, which is why many customers add our HVAC system cleaning to the same visit.
Frequently Asked Questions
Not much is needed. Make sure we can reach the furnace and the attic hatch or crawl space door. Move furniture or rugs that sit on top of floor vents if you can, and we'll help with anything heavy. Put pets in a closed room or outside, since the vacuum is noisy and we'll be going in and out. If you have a security system with motion sensors, plan to leave it off while we work.
In most cases, yes, and older sheet metal ducts often clean up better than new ones. The one thing we check first is insulation. Some ducts from that era were wrapped or taped with material that contains asbestos. If we see wrap that looks suspect, we don't disturb it. You'll get a photo of it, and you can have it tested before deciding what to do next.
Yes. A whole-house cleaning covers the supply runs, the return runs, the main trunk lines and every register and grille. Returns matter most, because all the air in the house gets pulled through them before it reaches the filter. When a quote just says "vents," find out if that includes the returns. Leaving them out means the worst of the dirt stays put.